I was under the impression that you would use the FSK jack on the rear. A RCA
type and not the RS-232
serial port.
Clayton N4EV
On Friday, December 6, 2013 10:12 AM, Gary <thewinks02@gmail.com> wrote:
I'm trying to send True FSK with my Omni VI Opt. 3 but haven't had much
luck.
I am running MMTTY on a PC with Windows 8.1 and a Startech FTDI to split up
a USB port. I have been using the Startech for other things and it has
worked well. The transceiver is a TenTec Omni VI Opt 3. I have run FSK
with it before.
MMTTY setup: Ver 1.68A Receives fine.
TX & FSK = EXTFSK/Normal
MISC = Com-TXD
When I try to transmit I get PTT but just a single tone, no diddle.
I have read that FSK normally uses +15 and -15 but I'm only get +6 and -6
volts.
The standard for using FSK with an Omni VI is to run pin 3 TXD and pin 5
ground with a 1K ohm resistor in the TXD connection to the serial port.
Does anyone have an idea what is going on and what I'm doing wrong
73, Gary N2UM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|