TenTec and related Items For Sale --
RF Speech Processor, HF linear amp, Power Supply,
DC Power Distribution Strip, CW Items, Connectors,
and more For Sale:
TenTec 715 RF Speech Processor:
The Model 715 RF Speech Processor is a high performance
true RF-type speech processor designed to operate with
most modern HF Amateur Radio transceivers. RF speech
processing is a superior system to traditional AF
systems found in a typical HF transceiver.
..Increase average SSB power output by up to 6 dB
..Enhance readability by stations hearing your signal
..Break pileups for DXpeditions faster
..Keep your net or contest run frequency clearer
..Easy to install, easy to operate
The 715 RF speech processor is installed between the
microphone and the microphone jack on your transceiver.
Two microphone inputs are provided -- an 8 pin microphone
connector wired for TenTec and Yaesu, and a 1/8” input
used for direct connection of microphones. 13 V DC required.
This particular unit works 100% and looks like new.
Paper work is included for $200.
Amp Supply LK-500 Z A, HF Linear Amplifier:
The LK-500 is an HF amp that runs a pair of 3-500 tubes, on
the 160 thru 10 meter bands, producing close to the legal
limit. On this amp, 30 watts of drive produces about 400
watts out of the amp; 50 watts gives about 650 Watts out;
etc.
This amp has a MUCH heavier duty Peter Dahl power transformer,
and covers 160 meters. It has a excellent tuned input matching
circuit. It is a superior amplifier.
This particular amp works very well. It has a manual step
start circuit added, and the electrolytic capacitors have
been replaced. Cosmetically it looks very, very nice. I
can not find a scratch on it. It looks like new.
Since this is heavy, I would much prefer pickup in the
Ocala, FL area.
With paper work for $900.
TenTec Switching Power Supply:
"Switcher / 25" 25 amp switching power supply:
This is a 25 amp switching power supply in a case that
matches the early Omni series case, with the metal bezel
around it. It is in a case that is the same size as a 243
remote VFO. It has an ammeter on the front, along with
Switch, TenTec logo, and output bulb. The front panel
basically looks like a 280 power supply with a metal bezel,
but says "Switcher/25" on it. It is very quiet, and well
shielded, and does not produce any electrical noise that
I could find. $170
MFJ 1118 DC Power Distribution Strip:
The MFJ-1118 is a versatile, high-current deluxe
multiple DC power outlet. It lets you power two HF
and/or VHF transceivers and six or more accessories
from your transceiver's main 13 V DC power supply.
You get two pairs of super heavy duty 30 amp 5-way
binding posts for powering your transceivers. Each
pair is individually fused and RF bypassed, capable
of a total of 35 amps.
An LED indicates power "ON". Six pairs of heavy duty,
RF bypassed 5-way binding posts lets you power your
accessories. They handle a total of 15 amps and are
protected by a master fuse, have an ON/OFF power
switch and an LED power indicator.
You get 6 feet super heavy eight gauge color-coded
cable with ring tongue terminals, plus a built-in
0 - 25 VDC monitor meter.
With paper work for only $60.
Cables for CW keyers and keys:
Cable for paddles
About 3 feet long, and with a 1/8 inch (3.5 mm) stereo
connector on the end, like used by most rigs. $8
As above, but 1/4 inch plug. $8
As above, with 1/4 inch GOLD plated plug. $15
Cable for straight key
About 3 feet long, with a mono 1/8 inch (3.5 mm) phone
plug on it, as used with a straight key. $5
As above, but 1/4 inch plug. $5
Coax connectors and adapters:
Prices are per connector. Several of each are available.
Most are unused.
SPECIAL: Buy 5 and take 10% off.
Buy 10 or more and take 20% off.
Amphenol UG-176 reducing adapters for PL-259 connectors to
use with RG-8 X or RG-59.
Still sealed in the package. $1
No longer sealed in package, 50 cents
UHF double female "Barrel connector" $3
UHF "Bulkhead Connector" - Double female, as above, but for
mounting thru a window, siding, etc. about 2 inches long $6
UHF double male connector $3
UHF "T" connector with two female (SO-239) and one male
(PL-259) connection $5
Antenna adapter to fit the BNC connector on the HT
and provide an SO-239 connector that will permit
a PL-259 to be attached. (BNC male to UHF female) $5
UHF Male to BNC female $5
BNC male for coax cables
standard type $2
crimp on type $3
Chassis mount BNC female
square mount (uses 4 screws) $3
screw in type $3
BNC "T", two female and one male $3
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs,
antennas, etc. Just too many things to list here.
Please e-mail your requests.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|