| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 422 Centurion blowing fuses... |
| From: | Jim Brown <k9yc@audiosystemsgroup.com> |
| Reply-to: | k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 02 Feb 2014 11:01:59 -0800 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On 2/2/2014 10:54 AM, Bob McGraw - K4TAX wrote: In that case likely the fault would be the bias control on the Bias/QSK board. I don't know anything about this particular amp, but it's pretty easy to troubleshoot most of the Titan 425 with a VOM, because except for the output tubes, it's virtually all discrete transistors and diodes. 73, Jim K9YC _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] 422 Centurion blowing fuses..., Bob McGraw - K4TAX |
|---|---|
| Next by Date: | [TenTec] Care and Feeding of Centurions, Richards |
| Previous by Thread: | Re: [TenTec] 422 Centurion blowing fuses..., Bob McGraw - K4TAX |
| Next by Thread: | Re: [TenTec] 422 Centurion blowing fuses..., Bry Carling |
| Indexes: | [Date] [Thread] [Top] [All Lists] |