| To: | "tentec@contesting.com" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair II Double Side Band Board (BFO) Problem |
| From: | Scott Shepard <scottsheppard@videotron.ca> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 17 Feb 2014 20:20:11 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Dave Forgive me jumping on to your post but given we are going thru the same process, thought I would ask...I do have a freq counter but if I set c1 and c2 ok, c3 is down about 70'hz or so...similarly, if I get c3 set to 9.000.00' c1 is about 9.004.33 and c2 about 9.001.40 ish ... Have you had much better luck? Scott va3ied Sent from my iPad _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Corsair II. DSB generator alignment???manual issues, Scott Shepard |
|---|---|
| Next by Date: | [TenTec] Power Supply temperature, Bry Carling |
| Previous by Thread: | [TenTec] Corsair II. DSB generator alignment???manual issues, Scott Shepard |
| Next by Thread: | [TenTec] Power Supply temperature, Bry Carling |
| Indexes: | [Date] [Thread] [Top] [All Lists] |