I got my Omni VII in September 2007. It has worked with my Herc II in QSK mode
from then until now. So I can't understand the comments in this thread. What am
I missing?
73.
John ND0N
JTT iPhone
> On Apr 11, 2014, at 14:02, Jon Kannegaard <kannegaard@comcast.net> wrote:
>
> No. They don't work together in QSK and never did. To make them work short
> D11 on the control board of the Hercules II.
>
> Hours of sleuthing and puzzling over the QSK circuitry and consulting with my
> friend Jeff (K6JCA) led to this conclusion. However, I could have found this
> out with a 5 minute call to Ten-Tec Service which I finally made after all
> the detective work.
>
> Jon
>
> PS: As long as we're on the subject of what Ten-Tec should build, how about a
> Hercules III? The II is a sweet amp if you don't mind the one cubic foot , 58
> pound power supply.
>
>> On Apr 9, 2014, at 8:30 AM, k6jek wrote:
>>
>> Anyone using the OMNI VII with a Hercules II QSK?
>>
>> It's not working here. I notice the H II drops the TX EN/Key out line from
>> 4.1 to 1.2 volts when it's keyed. This doesn't seem to be good enough for
>> the OMNI VII to think that TX really is enabled.
>>
>> Menu item in OMNI VII set to KEY LOOP ON.
>>
>> Jon
>>
>>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|