Don't forget the connectors inside the radio.
They need to be cleaned, too
Mike wb8vge
Sent from my iPad
On Jul 15, 2014, at 1:23 PM, "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de> wrote:
> Mike,
>
> I was thinking along those lines too.
> They "look" ok but it's hard to say.
> I was thinking about bending a burnishing tool 90 degrees (in its length),
> and then just polishing the pins.
> It's hard to believe the capacitors or inductors would have died.
> Dirty contacts are much more logical, especially because 40m was
> intermittent, and the rig has been sitting un-used for about 10 years.
>
> I'll keep you posted.
>
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Mike Bryce
> Sent: Tuesday, July 15, 2014 6:18 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Scout has vy low Pwr out on some bands
>
> Rick
>
> Check the barrel connectors.
>
> They route rf in and out of the module.
>
> The prongs get loose, causing the issues your having.
>
> Mike wb8vge
>
> Sent from my iPhone
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|