Seems would be time for internal connector cleaning project. It does take
time to remove one at a time, use a good contact cleaner, Deoxit etc, small
amount applied to a Q Tip, wipe the male pins and then plug in the
connector. Move on to the next one. The ones attached to PC boards on the
front are suspect.
If all else fails, call Paul at Tentec service for a RA number.
73
Bob, K4TAX
----- Original Message -----
From: "David W LeJeune, Sr" <lejeuned@centurytel.net>
To: <TenTec@contesting.com>
Sent: Friday, September 12, 2014 8:11 PM
Subject: [TenTec] Orion II Main Rx
Just fired up my Orion II for the first time in 2 years. It was working
perfectly when I last used it. Now I find that the main Rx isn't working.
Sub Rx works fine. Tx works fine. Both VFO's work fine. Any ideas
before
I bundle it up and send it back to TenTec?
Dave WN5V
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|