I'd also try the earphones. Sometimes the "monitoring" function works best
with earphones....no feedback.
I'll try it with my Eagle.
By the way, Stan said my noise blanker is on it's way....some Eagles were
shipped recently without the noise blanker.
Good luck.
John, N4DXI
-----Original Message-----
From: Robert <rmcgraw@blomand.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Fri, Oct 3, 2014 1:16 pm
Subject: Re: [TenTec] Eagle "MON" feature
It takes lot of turning of the MULTI knob. Test by scratching on the mike.
It's
not loud enough to cause feedback.
Bob, K4TAX
Sent from my iPhone
> On Oct 3, 2014, at 1:06 PM, Ronnie Zoerb <r.zoerb@live.com> wrote:
>
> Having had a new Eagle for about a month, I have a question about the “MON”
feature. Following the directions in the Operator’s Manual do not seem to
activate any monitoring of my audio out. I do see the “func” light come on but
hear nothing when I transmit by adjusting the “multi” knob. Has anyone else
experienced this or have any suggestions? Eagle Manual Directions: 1. Enter
Secondary Function Mode2. Place in transmit by pressing the microphone PTT
button.3. Toggle the Monitor Function on and off by pressing the “BAN”
button.4. You can now adjust the monitor level with the “MULTI” knob. Love the
Eagle so far. A real joy to use on CW! 73 Ron KI0II
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|