| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] termination Z |
| From: | "Paul Kraemer" <elespe@lisco.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 7 Nov 2014 12:11:44 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Does anyone know the proper terminating impedance for the crystal filters utilized in OMNI VI? I have some assorted filters from both if frequencies I would like to evaluate Thanks Paul K0UYA _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] can't service the omni-VI mixer, Al Gulseth |
|---|---|
| Next by Date: | Re: [TenTec] termination Z, g3ory@lineone.net |
| Previous by Thread: | [TenTec] TENTEC REPAIR, gary mankoff via TenTec |
| Next by Thread: | Re: [TenTec] termination Z, g3ory@lineone.net |
| Indexes: | [Date] [Thread] [Top] [All Lists] |