It is after the mixer and before the roofing filter. I don't have the
schematics handy where I am at, but I do recall it between those two segments.
I'll be back in my shack later tonight and can look at schematics then.
73 -EricW9WLW
From: Katz Ajamas <ajamas.rn@gmail.com>
To: tentec@contesting.com
Sent: Monday, December 22, 2014 1:17 PM
Subject: Re: [TenTec] Eagle 9MHz tap questions.
Eric-
I've carefully gone over the schematics and can not find the tap. They are
dated 2010 and I can not find any revision notes either. I will really
appreciate it if you can tell me where the 9MHz tap is located. To be
clear, I am not talking about the modification to add a second receiver
that is added after the low pass filters. The 9MHz tap should be somewhere
after the first mixer and before the second mixer. I just don't see it on
the schematics from the tentec web site.
73,
-Bob
> Message: 1
> Date: Sun, 21 Dec 2014 13:23:33 -0500
> From: "R. Eric Sluder via TenTec" <tentec@contesting.com>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Subject: Re: [TenTec] Eagle 9MHz tap questions.
> Message-ID: <5227AC58-CE90-4CC7-B482-2398FB193DA1@yahoo.com>
> Content-Type: text/plain; charset=utf-8
>
> Bob,
>
> I am in the "man cave" watching football and cannot answer your question
> directly; the schematics are online at TT and that is where I found the tap.
>
> 73
>
> -Eric
> W9WLW
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|