Re: [TenTec] Orion II won't flash

[Carl Moreschi <n4py3@earthlink.net>]

The oscillator in the Orion for the serial port that causes it run to 
run at 57600 baud may have drifted off frequency just enough to cause an 
error when lots of data is being sent to it.  I do remember way back 
that some Orions ran better at 56000 baud.  Does the firmware updater 
allow you to change the baud rate?
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 1/4/2015 7:44 AM, Barry N1EU wrote:
> Yes, no change.
>
> On Sun, Jan 4, 2015 at 12:38 PM, John T. Fleming<john@w3gqj.net>  wrote:
>
> > Barry,
> >
> > Have you tried rebooting the computer?
> >
> > 73,
> > John
> >
> > -----Original Message-----
> > From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry
> > N1EU
> > Sent: Sunday, January 04, 2015 5:53 AM
> > To: Discussion of Ten-Tec Equipment; Orion565; TTBUG@yahoogroups.com
> > Subject: [TenTec] Orion II won't flash
> >
> > Has anybody else ran across this issue or have some informed suggestions?
> > My logging software communicates fine with my Orion II but the latest
> > Updater (v4.15) reports communincation failure over the same serial port.
> > I've tried master reset/ram clear and power cycling without success.  The
> > exact same serial port (not a USB adapter) will flash my other Orions fine.
> >
> > Thanks&  Happy New Year,
> > Barry N1EU
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec