*Hello Ken,*
* The original manual which came with the rig, Has quite a
bit more information. The Omni 6 manual that I am currently looking at (
Thanks Jim Allen ) has part numbers, schematics and a great deal of
information. Theory of Operation for each Board and Function. When I traded
for my Paragon, the factory manual came with it. After loaning the manual
to a fellow and not getting it back. We learned that the manuals downloaded
from Ten Tec and others, are shortened/abridged versions. If you look
online, there are vendors who sell full reprints. After finally getting my
Paragon manual back. It will never leave the Shack again!*
* Hope we helped? 73 from Wade/KJ4WS*
On Sat, Apr 25, 2015 at 10:09 AM, Ken <kakoval@cox.net> wrote:
> Hello to the list. I am a new to Ten Tec products and am in search of
> information. I have just acquired a very nice Omni 6 Plus, Model 564, and
> would like to better understand it's technical details. I have been an
> amateur since 1956 with significant experience and am comfortable jumping
> into this rig. I have an original Operator's Manual but cannot seem to
> find additional detailed information such as a good block diagram, parts
> list, alignment information or preferably a service manual. Is this type
> of information available or must I be dependent on Ten Tec for any issues
> or problems that may arise? Any assistance in finding such detail would be
> greatly appreciated. Thanks...Ken, K9PGC
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|