In the first paragraph I said "making the receiver work down to 100
kHz." Early users of the new K3SYNA synth board in their K3s report
listening to signals in the experimental ham band below the AM broadcast
band and to services in the range of 300 kHz.
73, Jim K9YC
On Sun,5/17/2015 2:13 AM, Barry N1EU wrote:
I think they also added low frequency coverage.
Barry N1EU
On Sun, May 17, 2015 at 4:49 AM, Jim Brown<k9yc@audiosystemsgroup.com>
wrote:
>On Sat,5/16/2015 3:04 PM, Duane Calvin wrote:
>
>>What's different in the K3S from the K3?
>>
>
>Here's my take on it, after studying what Elecraft says on their website.
>(I didn't go to Dayton).
>
>New I/O board, solving a shortcoming with the original K3 and adding USB
>control and audio I/O via USB, new Synthesizer board, making a significant
>improvement in phase noise and also making the RX work very down to 100
>kHz. Improved audio from the speaker. Integrated RX preamp improves
>performance on 6M, 10M, 12M.
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|