TenTec
[Top] [All Lists]

Re: [TenTec] Looking for a manual for the ten tec 9420

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>, prosolar@sssnet.com
Subject: Re: [TenTec] Looking for a manual for the ten tec 9420
From: Wade Staggs <tvman1954@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 18 May 2015 14:53:32 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
*As you can see, it is basically Four independent power supplies in one
case. Pay close attention to the 4 pin power plug for the Ten Tec
Transceiver and the way that the 2 center pins turn the whole power supply
on and off. This is the same way the 960 is switched off and on with the
Corsair, Paragon and Omni Rigs. The only difference is that the Primary
Winding of the 960 is switched on and off and the 9420 uses a remote
voltage switching arrangement. Also, by looking at the Amplifier plug, you
can see the same setup. Besides those facts, the tiny manual really don't
have much more to offer. Sent to your home address also in case the files
did not make it on the reflector. I could really use a set of Load, Tune
and Band Switch knobs that are original for my SB-220. Please, quote me a
price if you have them. >>> 73 from Wade/KJ4WS <<<*


On Mon, May 18, 2015 at 1:24 PM, Mike Bryce <prosolar@sssnet.com> wrote:

> Gang,
>
> late staturday dayton hamvention find.
>
> A 9420 power supply that’s FUBAR
>
> I’ve looked on google, haven’t called ten tec yet, but does anyone have a
> PDF of the 9420 power supply manual?
>
> thanks.
>
> mike
>  wb8vge
>
> Mike Bryce, WB8VGE
>  the heathkit shop
> SunLight energy systems
> J e e p
> o|||||||o
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>