To: | "tentec@contesting.com" <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Model 544 (or that era) part source needed |
From: | Peter Bertini <radioconnection@gmail.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 5 Aug 2015 11:00:36 -0400 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Those LED displays date back to the 1970's, or maybe even a bit earlier. The 54 used HP-5082 series LEDs for all counter sections... these 7 section LED displays were .43" (10.92mm) and common cathode, with right hand decimal points. The correct LED for the green display is a HP 5082-7671. You could substitute a red display--HP 5082-7651, or a yellow display, HP 5082-7661. The red displays are extremely common and show up on eBay. The green and yellow displays are tad more uncommon, but this should still be a 1 to 5 dollar part on the surplus market since zillions were made. regards Pete k1zjh _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] TT high prices, Tony Lelieveld |
---|---|
Next by Date: | [TenTec] Inrad 2400Hz 9mHz filter needed, Mark Kenward |
Previous by Thread: | Re: [TenTec] Model 544 (or that era) part source needed, Vic Klein |
Next by Thread: | [TenTec] Inrad 2400Hz 9mHz filter needed, Mark Kenward |
Indexes: | [Date] [Thread] [Top] [All Lists] |