TenTec
[Top] [All Lists]

Re: [TenTec] Orion Serial port data......

To: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion Serial port data......
From: Tim Wininger <ky5rtim@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 15 Sep 2015 15:55:55 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
TNX Carl and Terry fer the replies...just needed confirmation on this issue.

GE Tim, AB4B

On Tue, Sep 15, 2015 at 3:23 PM, Carl Moreschi <n4py3@earthlink.net> wrote:

> Yes, the Orion is fixed at 57600 8 N 1.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>
> On 9/15/2015 3:53 PM, Tim Wininger wrote:
>
>> I have lost my three PC's that run my station of 2 x Orion's (565) in
>> multi-op mode.
>>
>> All I can find is 57,600 8 N 1 handshake via TT site.
>>
>> Is this correct or has there been a change in port settings on radio.
>> It appears port is not adjustable. Was using 2nd gen Hamation gear
>> that required 9600 if my memory serves me right. I know I shud have
>>   documented these settings!
>>
>> Have new PC's (Win7 vice XP) and gone to N1MM Plus.........
>>
>> TNX fer any info,
>>
>> Tim, AB4B
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>