TenTec
[Top] [All Lists]

Re: [TenTec] TT orion rf tune level adjustment

To: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] TT orion rf tune level adjustment
From: denton sprague <denton@oregontrail.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 23 Dec 2015 15:46:08 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I use your fb software a lot also…but was looking for a setting from the front 
panel or internally on the Orion….
Merry Christmas everyone!

> On Dec 21, 2015, at 12:36 PM, Carl Moreschi <n4py3@earthlink.net> wrote:
> 
> You can do that with my N4PY Orion software by setting a tune power.
> 
> 
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
> 
> On 12/21/2015 3:20 PM, denton sprague wrote:
>> I run an orion with a palstar hf auto that requires only about 1-2 watts of 
>> rf drive to auto tune…
>> is there an internal pot or setting to tweek from default setting of about 
>> 10 watts to 1-2 watts?
>> 
>> I usually back down rf output to about 1-2 watts to get the tuner to fire 
>> and i works fine, but would be nice to leave the power out level set to 100 
>> watts and have only a couple of watts rf output while in tune mode.
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>