| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] frequency calibration on OMNI-V |
| From: | wt4t@reagan.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 7 Jan 2016 07:45:59 -0600 (CST) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
If your using a stock OMNI-V ,No N4PY chip, how do you calibrate the display, if not reading correctly? On 14.300 I read 14. 299.87. Read thru the manual but must have missed it . Would really appreciate any guideance on this. 73 dale wt4t _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Service, Gary J FollettDukes HiFi |
|---|---|
| Next by Date: | Re: [TenTec] frequency calibration on OMNI-V, Barry N1EU |
| Previous by Thread: | Re: [TenTec] Orion II Battery, Rick W |
| Next by Thread: | Re: [TenTec] frequency calibration on OMNI-V, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |