TenTec
[Top] [All Lists]

Re: [TenTec] Paragon vs Paragon II - PLL

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon vs Paragon II - PLL
From: k7mks@comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 21 Jan 2016 04:48:22 +0000 (UTC)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Thank you Bob 

joe k7mks 

----- Original Message -----

From: "Gary J FollettDukes HiFi" <dukeshifi@comcast.net> 
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> 
Sent: Wednesday, January 20, 2016 6:53:02 PM 
Subject: Re: [TenTec] Paragon vs Paragon II - PLL 

AND they nipped the through hole leads on the parts too short… 

Gary’ W0DVN 
> On Jan 20, 2016, at 8:43 PM, Bwana Bob <wb2vuf@verizon.net> wrote: 
> 
> I believe that they redesigned the PLLs for the Paragon II. The main issue 
> with the PLL boards in the original Paragon was poor tinning of the component 
> leads and the PWB. 
> 
> 73, 
> 
> Bob WB2VUF 
> 
> On 1/19/2016 9:29 PM, Gary J FollettDukes HiFi wrote: 
>> I can’t speak insider facts here but I have had many Paragon 2 radios and 
>> none of them had PLL issues. 
>> 
>> Gary 
>> 
>> 
>> 
>>> On Jan 19, 2016, at 5:17 PM, steve jobes via TenTec <tentec@contesting.com> 
>>> wrote: 
>>> 
>>> I have not had any problems with my paragon 2, and can't recall hearing of 
>>> any issues with them. 
>>> 
>>> 73, 
>>> Steve W1DXH 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> -----Original Message----- 
>>> From: k7mks <k7mks@comcast.net> 
>>> To: Discussion of Ten-Tec Equipment <tentec@contesting.com> 
>>> Sent: Tue, Jan 19, 2016 6:14 pm 
>>> Subject: [TenTec] Paragon vs Paragon II - PLL 
>>> 
>>> Did Ten Tec make any performance improvements (ie soldered board 
>>> conections, etc) in the later #586 PLL over the earlier #585 PLL's ? 
>>> 
>>> Thank you. joe k7mks 
>>> _______________________________________________ 
>>> TenTec mailing list 
>>> TenTec@contesting.com 
>>> http://lists.contesting.com/mailman/listinfo/tentec 
>>> 
>>> _______________________________________________ 
>>> TenTec mailing list 
>>> TenTec@contesting.com 
>>> http://lists.contesting.com/mailman/listinfo/tentec 
>> _______________________________________________ 
>> TenTec mailing list 
>> TenTec@contesting.com 
>> http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec@contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________ 
TenTec mailing list 
TenTec@contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>