That's the frequency you get when the VFO stops running. You also get
this when you unplug the VFO jumper in the back of the radio. I would
unplug and replug this jumper a few times to clean it and see if that
corrects the problem.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 1/24/2016 10:28 AM, Frederick Kilburn via TenTec wrote:
The display on my OMNI-D is fine on all bands except after warm up
the 28MHZ display changes to 9MHZ. The output frequency remains correct.
Ideas anyone?
TN X
FRED W2VUF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|