To: | tentec@contesting.com |
---|---|
Subject: | [TenTec] Equipment Black Corner Pieces |
From: | Fred <n8yx@neo.rr.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 27 Jan 2016 13:52:53 -0500 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Short answer: The Auction Site or your local hamfest/mailing list (for
junker rigs) if Ten-Tec isn't producing these.
Long answer: 3D printing or someone with a mold shop goes into business reproducing this part and the ubiquitous T-T selector knobs then makes a tidy bit of coin. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] OMNI VII ??, Barry N1EU |
---|---|
Next by Date: | [TenTec] Omni 6 Metering Problem, jackay |
Previous by Thread: | [TenTec] OMNI VII ??, David Perrin |
Next by Thread: | [TenTec] Omni 6 Metering Problem, jackay |
Indexes: | [Date] [Thread] [Top] [All Lists] |