My mistake? I thought you said you need the Paragon. The P2 is a lot different
than the Paragon.
Mine was synthesizer dead when I got it so I do not yet know if the NB works as
it should.
73
Gary
> On Feb 9, 2016, at 11:59 PM, k7mks@comcast.net wrote:
>
> Thank you Gary. Does your P II noise blanker work it should or does it
> nothing like mine does?
>
> Joe k7mks
>
> ----- Original Message -----
>
> From: "Gary J FollettDukes HiFi" <dukeshifi@comcast.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Tuesday, February 9, 2016 7:48:52 PM
> Subject: Re: [TenTec] Paragon II Manual
>
> I purchased a complete service manual.
>
> Let me look for you, tomorrow evening.
>
> Gary
>
>> On Feb 9, 2016, at 9:21 PM, k7mks@comcast.net wrote:
>>
>> Help! I need a schematic showing board interconnections, front and rear
>> panel wiring etc. My manual only shows individual board wiring and photos.
>>
>> Many thanks joe k7mks
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|