| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Replacing battery in Orion II |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 16 Feb 2016 13:24:03 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Try unplugging the cables to the sub receiver, check for bent pins, and
if there is any discoloration on the pins/ sockets, spray some deOxit on
them. Then plug the cable back in. Be sure if a double ended connector
set up, to check both ends.
GL, Stuart K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Updating via a Mac running Parallels?, Froiseth Richard |
|---|---|
| Next by Date: | Re: [TenTec] Replacing battery in Orion II, Barry N1EU |
| Previous by Thread: | Re: [TenTec] Replacing battery in Orion II, Billy Cox |
| Next by Thread: | Re: [TenTec] Replacing battery in Orion II, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |