The manual (my Omni VI+) will guide you thru the BFO alignment procedure.
I hope W4TAX will reply to your question too. I consider Bob to be the expert
on this issue. My Omni went that route a few months ago and I had to go
thru it. You'll need a good freq counter and a deft hand.
I think this is due to xtal aging. After all, these things are quite old. HI
73 Clayton N4EV
--------------------------------------------
On Wed, 6/15/16, Dry Martini Holding Company😎 <qrp@kg4kgl.net> wrote:
Subject: [TenTec] Omni V
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Wednesday, June 15, 2016, 4:34 PM
I have an Omni V with the N4PY V.9 upgrade. A problem has
recently surfaced. On 40m for instance, when I am talking to
someone on say 7115khz, I have to tune the rig to 7114.2.
IOW, my freq display is reading lower than actual.
On 20m I had a QSO on 14056, but my display shows 14057.
What. Involved in calibrating the freq display?
Tnx,
Robert
KG4KGL
Sent from my iPhone
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|