http://www.tentecwiki.org/doku.php?id=565lpf_remove
Barry N1EU
On Mon, Jul 18, 2016 at 6:37 PM, Joe Papworth via TenTec <
tentec@contesting.com> wrote:
> Hi Lee,
> I wonder if it's similar to the Omni 6.
> There's a procedure I wrote for doing it on the Omni 6 Plus that Barry
> stored somewhere in his wiki pages.
> If u can't find it, let me know. I'm sure I still have the file somewhere.
>
> Later, Joe, K8MP
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Bryan Lee Cornwell <blcornwell@k2blc.com>
> To: Ten-Tec mailing list <tentec@contesting.com>
> Sent: Mon, Jul 18, 2016 04:39 PM
> Subject: [TenTec] Omni V Relays
>
>
> Has anyone replaced the relays on the low pass filter board on the Omni
> V ?. I've found some posts on the reflector referencing Paragon
> replacements. Are they the same?
>
> I need at least 5 and I may replace all of them while I have the board out.
>
> Thanks in advance
>
> Lee K2BLC
>
>
> --
> Bryan Lee Cornwell
>
> <a href="mailto:blcornwell@k2blc.com";>blcornwell@k2blc.com</a>
>
> <a href="http://k2blc.com"; target="_blank">http://k2blc.com</a>
>
> _______________________________________________
> TenTec mailing list
> <a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
> <a href="http://lists.contesting.com/mailman/listinfo/tentec";
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|