TenTec
[Top] [All Lists]

Re: [TenTec] service/repair ?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] service/repair ?
From: Kartooo <kartooo@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 19 Jul 2016 17:49:09 +0000 (UTC)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
reasonable price by today's standards ? 
Larry 
n1yw 

----- Original Message -----

From: "John Bescher via TenTec" <tentec@contesting.com> 
To: tentec@contesting.com 
Cc: "John Bescher" <n4dxi@aol.com> 
Sent: Tuesday, July 19, 2016 12:26:54 PM 
Subject: Re: [TenTec] service/repair ? 

I sent my Orion 2 for repairs to Tentec last month with mixed feelings about 
how long repairs would take. To my surprise and delight, the rig was sent back, 
successfully repaired, in a week, battery and capacitors replaced. 


John Bescher, N4DXI 



-----Original Message----- 
From: Kartooo <kartooo@comcast.net> 
To: tentec <tentec@contesting.com> 
Sent: Tue, Jul 19, 2016 12:23 pm 
Subject: [TenTec] service/repair ? 

been a member off and on here through out the yrs, owned many a ten tec rig and 
send a few in for repair. 
has anyone sent their radio in for repair lately ? 


i shipped my omni VII down there yesterday and i'm hoping for a positive 
turnout. 
the mic amp board was doing funny stuff, a bunch of loud static and humming 
whenever the mic cable was disturbed. 
any mic, any cable on TX ssb. even when keyed by the KEY. just kept getting 
worse 
i removed the case, 4 screws on the face, moved the face fwd just a bit to take 
the 3 screws that retain the mic amp board to the face and saw nothing...... 
re soldered all 8 mic pins, no luck 

searched the board over with a 10X lens. did this routine 4X's and could not 
find a thing. 
gave in and wrote ten tec, took about 3 weeks for this reply: 

Our service policy is there will be a one hour minimum charge of $140.00 
dollars for each transceiver or equipment sent in for repair. If more than one 
hour is needed to make the repair then additional charges of $125.00 dollars 
per 
hour for each hour needed to make the repair. Any parts used for the repair and 
return shipping are additional charges. Turn-around time on repairs have been 
two to three weeks 
keeping my fingers crossed, should be in TN on thurs. 
Larry 
n1yw 




_______________________________________________ 
TenTec mailing list 
TenTec@contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________ 
TenTec mailing list 
TenTec@contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>