after letting the rig sit with the power supply off for an hour or so, the rig
is now performing normally….beginning to suspect something amiss in the relay
circuit.
relay going south maybe?
> On Jul 27, 2016, at 10:12 AM, Carl Moreschi <n4py3@earthlink.net> wrote:
>
> Are you sure it is the switch and not the relay that the switch controls?
>
> No problem using the power supply switch with the Orion.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 7/27/2016 12:34 PM, denton sprague wrote:
>> curses! foiled by spell correct again!!
>> poem= o e m
>>
>>> On Jul 27, 2016, at 9:17 AM, denton sprague<denton@oregontrail.net> wrote:
>>>
>>> the power switch has just failed in the on position on my orion 2….how hard
>>> to replace and is there an aftermarket switch I can use in its stead that
>>> looks like poem?
>>>
>>> ok to use the power supply switch for rig power on and off in the meantime?
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|