TenTec
[Top] [All Lists]

Re: [TenTec] Paragon tuning knob needed

To: <tentec@contesting.com>
Subject: Re: [TenTec] Paragon tuning knob needed
From: "Vic Klein" <vhklein@ptd.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 17 Sep 2016 05:55:56 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
That is the same knob used right through the Omni VII, so you should be able
to get one fairly easily, even from Ten Tec if you want a new one. I see
knob sets from rigs like the Omni V on the on-line auctions from time to
time.

=Vic=
WA4THR

--------------------------------------------------------
Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon tuning knob needed.
From: w8au@sssnet.com
Reply-to:Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 17 Sep 2016 02:34:12 -0400

Anyone parting out a Paragon?  (I dread that thought) :-[

Restoring a Paragon where the original owner (SK) managed to hollow out the
entire finger detent by tuning with the
eraser end of a pencil.  (hard to imagine, I know...)

Perry w8au 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>