Unless you physically break the internal parts, there is little reason to
replace them. Just disassemble the thing, clean everything that moves, and
reassemble with light application of a good modern lubricant.
If your brass main shaft is worn beyond use, I can make those. I have raw stock
and simply lather turn the groove where the balls ride and then cut to proper
length.
Gary
> On Oct 14, 2016, at 7:47 AM, Howie WA3MCK <wa3mck@gmail.com> wrote:
>
> Does TenTec still sell PTO kits for the Century 21 CW Transceiver?
>
> Tnx es 73 de Howie WA3MCK
>
> On Friday, October 14, 2016, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
>> If you're talking about the switch directly under the RX Antenna jack
>> marked "RX" and "TRX", and you don't have anything plugged into that jack,
>> the answer is "TRX".
>>
>> Barry N1EU
>>
>> On Fri, Oct 14, 2016 at 3:58 AM, Dale Putnam <daleputnam@hotmail.com
>> <javascript:;>> wrote:
>>
>>> Hey Hi Howdy
>>> A quick question for a friend. On an Omni V. There is a toggle switch
>>> on the back panel marked rx tx. Which direction would the toggle be
>>> placed for normal cw tx and rx ? Thank you
>>>
>>> 72,
>>> Dale - WC7S in WY
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com <javascript:;>
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com <javascript:;>
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|