Fernando, thank you. I have been moving toward changing out the power
connector. Can you give me the part numbers
for the devices to change out. Also, are there any videos available on the
internet to show one how to get at that
power connector. I have been searching for them but no luck so far.
73,
Louis C Loria, W0QQG
-----Original Message-----
From: Fernando <n2fq@sbcglobal.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Thu, Nov 3, 2016 4:05 pm
Subject: Re: [TenTec] Jupiter power problem
Hello.
I would make certain that the ground connection is still true.
RF getting into the rig will mimic this behavior.
I would also check the power connector, the fuse and fuse holder.
This was a reason that I did the Molex to Power Pole conversion
six years ago. No problem since.
Fernando N2FQ/6
n2fq@sbcglobal.net
> On Nov 3, 2016, at 11:53 AM, Louis C Loria via TenTec <tentec@contesting.com>
> wrote:
>
>
> My Jupiter has a problem where it will act as though there is a power surge
> when I hit the transmit button.
>
> The screen on the Jupiter goes blank and I hear all the relays cycle and then
> I have to recycle the on-off
>
> switch and it comes back to life ok. Sometimes it will go for a couple of
> days without doing this and then
>
> it might do it two or three times in a day. Any ideas?
>
> Louis C Loria, W0QQG
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|