TenTec
[Top] [All Lists]

Re: [TenTec] Orion II Black Screen - Successful Repair

To: tentec@contesting.com
Subject: Re: [TenTec] Orion II Black Screen - Successful Repair
From: Joe Papworth via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 15 Dec 2016 20:02:37 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
That's good stuff Bob. I think Barry saves good write-ups in his Ten Tec Wee 
Willy Wonka Wiki pages. 
I don't own an Orion II but your info is gonna help somebody at some point .

Later,  Joe,  K8MP

Sent from AOL Mobile Mail


-----Original Message-----
From: bobk8ia--- via TenTec <tentec@contesting.com>
To: tentec <tentec@contesting.com>
Cc: BobK8IA <BobK8IA@aol.com>
Sent: Thu, Dec 15, 2016 06:56 PM
Subject: [TenTec] Orion II Black Screen - Successful Repair



This is a follow up to my email below from 24 October 2016. 
 
As of 12/14/16, my Orion II is successfully repaired now, thanks to good  
friend Kevin W9CF. What had failed was some component(s) on the 12v to 1800v  
inverter board that powers the cfl backlight. 
 
A new inverter board (TDK CXA-L0612A-VJL which is DigiKey part #  
445-1619-ND; about $23) has the radio up and running like new. 
 
<a 
href="http://www.digikey.com/product-detail/en/tdk-corporation/CXA-L0612A-VJL/445-";
 
target="_blank">http://www.digikey.com/product-detail/en/tdk-corporation/CXA-L0612A-VJL/445-</a>
1619-ND/652720
 
Thought some of you real techies would like to know this. Thanks to those  
of you that responded to me directly.
 
73, Bob K8IA
Arizona Outlaws Contest Club
 
-----------------------
 
 
In a message dated 10/24/2016 8:15:20 A.M. US Mountain Standard Time,  
<a href="mailto:BobK8IA@aol.com";>BobK8IA@aol.com</a> writes:

Gents;
 
I am getting ready for our annual Multi-Two N7AT fun in CQWW SSB, this  
weekend. One of the op positions my Orion II. I turned the Orion II on  and no 
screen appeared, just blank/black. The radio appears to be functioning  fine 
but no screen. It does not appear to be power supply related.
 
It worked fine two days ago (and generally trouble free since 2006 when I  
bought it new). Latest firmware 3.033xe installed and RX-366. Battery was  
recently replaced.
 
Any guidance you can give me. The radio is contest-unusable as is.
 
TNX.
 
73, Bob K8IA
Arizona Outlaws Contest  Club


_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec"; 
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>