TenTec
[Top] [All Lists]

Re: [TenTec] HELP with broken off screw threads

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] HELP with broken off screw threads
From: Bryan Lee Cornwell <blcornwell@k2blc.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 24 Dec 2016 10:12:12 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 12/24/2016 10:06 AM, Peter Frenning [OZ1PIF] wrote:
Den 24-12-2016 kl. 16:02 skrev Barry N1EU:
The threaded end of an aluminum screw broke off in one of the PCB mounting posts in my Omni 6+. Please have a look here: http://n1eu.com/screw1.jpg

I'd very much appreciate advice on how to remove that screw end.

Thanks & 73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

Sorry Barry, I only get a partial picture...


I think a small "E-Z out" will work....something similar to this:

http://www.sears.com/irwin-hanson-5-pc-spiral-screw-extractor-set/p-SPM7648639823?plpSellerId=Antonline.com&prdNo=38&blockNo=38&blockType=G38

73

Lee K2BLC


--
Bryan Lee Cornwell

blcornwell@k2blc.com

http://k2blc.com

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>