TenTec
[Top] [All Lists]

Re: [TenTec] Is this the encoder used in the Orions?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Is this the encoder used in the Orions?
From: Jim Allen <jim.allen@longhornband.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Dec 2016 13:41:17 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Ewww, are you lucky!  I had to replace the encoder on a K2 earlier this year.  
The encoder cost $125, the single most expensive part on the entire radio, 
including the threaded collar. 

73 Jim Allen W6OGC 

Sent from my iPad

> On Dec 27, 2016, at 13:27, Barry N1EU <barry.n1eu@gmail.com> wrote:
> 
> No, for starters you need an encoder with a threaded collar.
> 
> 73, Barry N1EU
> 
>> On Tue, Dec 27, 2016 at 1:59 PM, Paul K. <hglent@frii.com> wrote:
>> 
>> I found this on a parts house listing. Is it the encoder that is usable on
>> our Orions?
>> 
>> http://www.goldmine-elec-products.com/prodinfo.asp?number=G20056C
>> 
>> 
>> Paul K
>> WA0BAG
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>