TenTec
[Top] [All Lists]

Re: [TenTec] Omni D WARC mods?

To: tentec@contesting.com
Subject: Re: [TenTec] Omni D WARC mods?
From: Al Gulseth <wb5jnc@centurytel.net>
Reply-to: wb5jnc@centurytel.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 11 Feb 2017 19:38:46 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Tom,

While many of the parts are off-the-shelf, certain parts are "unobtainium" - 
in particular, the bandpass filter transformers which are described in the 
manual as "over-coupled" and thus not easily duplicated. Copies of the 
modification instructions are probably out there, but it might take some 
patient searching. The easiest way to possibly get the parts might be if you 
could find an 80712 BPF board from a basket case Omni-C as it came with the 
WARC bands installed; the "C" appears as if it may use the same "mission 
critical" parts even though the BPF board layout is different.

Keep us posted concerning what you come up with.

73 es GL, Al

On Sat February 11 2017 3:56:42 pm tfr001@myfairpoint.net wrote:
> I know there were a couple of WARC mods available for the Omni D. Can you
> still buy the parts? If not, does anyone have details of what is
> involved... like the instruction sheet  from TenTec?  Schematics would be
> helpful. This rig isn't difficult to work on, so maybe I could come up with
> something. 73,
> -Tom N1OOQ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>