TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ no output on 20 m

To: tentec@contesting.com
Subject: Re: [TenTec] Omni VI+ no output on 20 m
From: Joe Papworth via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Feb 2017 01:20:10 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hi Stan,
Replace both 20M relays on the low pass filter board. 99.9% chance that'll fix 
it.

Later, Joe, K8MP

Sent from AOL Mobile Mail


-----Original Message-----
From: Stan Lloyd <kd8ln.stan@gmail.com>
To: tentec <tentec@contesting.com>
Sent: Sun, Feb 19, 2017 09:50 PM
Subject: [TenTec] Omni VI+ no output on 20 m


Hi,

I have an Omni VI+ that has stopped putting out any power on 20m in any mode. 
It switched into transmit mode, and in CW It generates the side tone, but based 
on the internal meter and an external power meter it gives absolutely zero 
power output. It transmits fine with regular output on the other bands. Any 
ideas on how to approach this? 

I did try resetting the microprocessor, but no change. 

Thanks and 73,

Stan KD8LN


Stan
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec"; 
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>