| To: | "tentec@contesting.com" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Orion II Power Connector Replacement |
| From: | Rod Greene via TenTec <tentec@contesting.com> |
| Reply-to: | Rod Greene <w7zrc@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 1 Mar 2017 14:25:39 +0000 (UTC) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I'm pretty sure I've got the bad power connector problem. Rig intermittently gives a loud "POP" and then reboots. What's the best recommended solution? Solder the power cable directly to the board without the molex connector - or - do the power pole replacement? I'm leaning to the direct wire mod. Suggestions please! Thanks and 73, Rod/w7zrc _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] 709a, Ralph Arnold |
|---|---|
| Next by Date: | Re: [TenTec] 709a, Barry N1EU |
| Previous by Thread: | Re: [TenTec] 709a, Ralph Arnold |
| Next by Thread: | Re: [TenTec] Orion II Power Connector Replacement, denton sprague |
| Indexes: | [Date] [Thread] [Top] [All Lists] |