To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | [TenTec] Paragon low power Output |
From: | Steve Cochrane <w7jsc@msn.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Tue, 28 Mar 2017 02:58:10 +0000 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
My Paragon puts out full power on 80 meters, but has low power output on all the other bands. Is there a Paragon expert out there that can point me in the right direction on troubleshooting this problem? I'm using a 50 ohm dummy load of course. It had full output on all bands until one day I turned it on and I couldn't get full power. The amps (Ip) look about where it should be, but output is way down. Steve w7jsc _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TenTec] The TenTec Signalizer Model S-30, budw2gln--- via TenTec |
---|---|
Next by Date: | Re: [TenTec] Paragon low power Output, w8au |
Previous by Thread: | [TenTec] The TenTec Signalizer Model S-30, budw2gln--- via TenTec |
Next by Thread: | Re: [TenTec] Paragon low power Output, w8au |
Indexes: | [Date] [Thread] [Top] [All Lists] |