During SSCW I noticed (after a few hours of operating) the number 9 creeping in
from the right side of the display. It never completely became visible, but was
definitely there and in large font. Later on in the SS a third megahertz number
appeared on top of the regular megahertz numbers for each VFO. I could correct
this easily by turning the OII off and back on. I was using N1MM+ in SO2V mode.
Any thots on this or other similar experience? I have replaced the A9 board
caps last year. And the display is working fine today.
Thanks and 73, Rod/w7zrc
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|