[TenTec] Omni C on 160

[Shawn Upton <kb1ckt@yahoo.com>]

Finally added a 135' wire to my Hustler 6BTV so as to see if I could get onto 
160m.  Band seems more quiet than 80m--but that could be a number of factors, I 
guess.  One thing I've noticed though is that the RX preselector (aka resonate 
control) uses the same setting as it does on 80m.  Is this normal?
I also noticed that I have to use "lots" of RF gain, more than on 80m--but that 
could be antenna related--but I noticed one eham review that said the Omni C 
had low sensitivity on 160m.  Is that normal?  I don't think I mind, with my 
setup I don't need extra gain.
shawn kb1ckt