You can substitute a different filter in place of the 500 Hz or 250 Hz filter ,
but that's about it.
The 1.8 kHz filter is the narrow SSB filter. If you never use it for SSB, then
it could be substituted as well.
But that's as far as it goes, without major circuit and system changes.
73, ron W3WN
-----Original Message-----
From: Shawn Upton via TenTec <tentec@contesting.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Cc: Shawn Upton <kb1ckt@yahoo.com>
Sent: Mon, Dec 4, 2017 2:28 pm
Subject: [TenTec] Corsair question
Can the Corsair take three cw filters? I tried running the 160m CW contest this
past weekend, and I found myself wanting a tighter filter than 500Hz. Problem
is, I like the 1.8kHz and 500Hz filters that my Omni C already has. [I know I
could swap the 1.8 for 250 but it might get tiring to open up the radio.]
Wondering if a Corsair would take three, but some casual googling has not
revealed an answer. shawn kb1ckt
_______________________________________________ TenTec mailing list
TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|