Are you saying keying loop #2 works with the amp connected to TX Out2/TX
En2? If not, what is connected to those jacks?
73, Barry N1EU
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
Virus-free.
www.avg.com
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
On Sun, Dec 10, 2017 at 5:41 PM, Michael Marx <sndtubes@vacuumtubes.com>
wrote:
> Hi Guys,
>
> I have been dealing with a sick Centurion. Still having problems. I am
> going to rebuild the QSK board and try again.
>
> However, when I was testing the Centurion with my Orion 1, I had keying
> loop 1 connected and it was working….for a short time. Something happened
> when I was testing and suddenly the amp would no longer key. I think the
> problem lies in the QSK board. I’m sure something failed there again.
>
> But, when the amp stopped keying, so did the radio. If I have the keying
> loop turned on, the radio will not key at all. If I turn the key loop off,
> the radio keys fine. if I turn on keying loop #2, the radio keys fine. So
> the radio keys fine except when I have key loop 1 turned on in the menu.
>
> So my question is, have I damaged keying loop #1? If so, what do I need
> to do to fix it?
>
> thanks for all of the expert advice!
>
> 73
> Mike WB0SND
>
> Michael Marx
> sndtubes@vacuumtubes.com
> 636-939-9190
>
> SND Tube Sales
> 105 N. Division St.
> Bonne Terre, MO 63628
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|