I'm rehabbing an older Omni D (Series B) and it looks like the wiring on the
VOX board is wrong. VOX is 80451. It looks like I have the following:-red
(12V)-white with orange stripe (speaker)-white with yellow stripe (? T/R?)-coax
marked as #3 (mic?)
I think I'm missing a GND (can't find where this board gets GND from) and there
is one solder terminal that is unused.
Anyhow: I had to lift the speaker connection to this board as it is clamping to
60mV of audio, so it's clearly miswired. This is a used radio, and I know 100%
for sure that the PTO was removed, although the wiring on this VOX board looked
unmolested--but one never knows.
I'd open up my Omni C but at the moment it's buried behind this D! Might
someone have a pic or know what I should look for?
shawn kb1ckt
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|