I haven't experienced it in my Paragon but I have read other post where that
issue was traced to shorted PIN diodes in the LPF.
-----Original Message-----
From: TenTec <tentec-bounces@contesting.com> On Behalf Of Richard via TenTec
Sent: Tuesday, March 13, 2018 8:23 PM
To: tentec@contesting.com
Cc: w2ssx@yahoo.com
Subject: [TenTec] paragon 1
Paragon rx and tx all bands except on 80 where there is no output but weak
receve signal.when I connect the antenna to the aux. ant jack ,on back of
radio,by passing the low pass filter board,receve signal is normal but,
still no output .think problem in lpf board .having trouble,trouble
shooting. any ideas appreciated. thanks rich (w2ssx@yahoo.com)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|