Thanks Dave.
Later, Joe
Sent from AOL Mobile Mail
-----Original Message-----
From: David Perrin <dbperrin@gmail.com>
To: tentec <tentec@contesting.com>
Sent: Sun, Mar 18, 2018 03:52 PM
Subject: [TenTec] OMNI VI and TL-922A
From: <a href="mailto:k8mp@aol.com";>k8mp@aol.com</a>
To: <a href="mailto:tentec@contesting.com";>tentec@contesting.com</a>
Subject: [TenTec] Omni VI Plus w/ TL-922A
Message-ID: <16235414fe2-179d-6724@webjas-vaa223.srv.aolmail.net>
Content-Type: text/plain; charset=utf-8
Gents,
Has any one run an Omni VI Plus with a TL-922A? I'm planning on acquiring a
922A and am wondering if there are any things I should be aware of in
advance.
========================================================================================
I had run my OMNI VI + and a TL922a amplifier on CW with QSK keying. You
need the amp switching to be a hint faster than the T/R switching to avoid
hot switching the amp. I chose to use the AG6K vacuum relays circuit. It
was a job fitting the parts but the wiring was straight forward. On SSB the
switching rate of a stock TL-922a is fast enough, but not for CW.
73 de Dave, K1OPQ/4
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|