Are you sure the meter is not just stuck?
Does the meter zero out when you turn the radio off?
Gary
> On Apr 24, 2018, at 6:52 PM, Troy, W6HV <w6hv@verizon.net> wrote:
>
> Thanks, Mike. I have that calibration procedure, but the S meter is way high
> and I need to put it back to zero when there is no signal present (short out
> the ant input). I should have been more explicit in my cry for help.
> 73,
> Troy, W6HV
>
> -----Original Message-----
> From: Mike Pagel
> Sent: Tuesday, April 24, 2018 4:12 PM
> To: 'Discussion of Ten-Tec Equipment'
> Subject: Re: [TenTec] zero adjust S meter in Orion II
>
> http://www.tentec.com/wp-content/uploads/2016/05/S-Meter_565_566_Calibration_Procedure.pdf
>
> 73, de Mike, K9UW
> Amherst, WI
>
> -----Original Message-----
> From: TenTec <tentec-bounces@contesting.com> On Behalf Of Troy, W6HV
> Sent: Tuesday, April 24, 2018 5:44 PM
> To: tentec@contesting.com
> Subject: [TenTec] zero adjust S meter in Orion II
>
> I can't recall (or find) the way to zero the S meter in my Orion II. I have
> the procedure for calibration. Any help?
>
> Thanks,
>
> Troy, W6HV
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|