TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI Serial Port

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI Serial Port
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 24 Jul 2018 01:03:55 +0000
List-post: <mailto:tentec@contesting.com>
Rig control works with the serial port.

73, Barry N1EU

On Tue, Jul 24, 2018 at 12:24 AM, Stan Gammons <s_gammons@charter.net>
wrote:

> Hi All,
>
> I could of sworn I ask this before, but I looked in my archive and the
> TenTec archive on contesting.com and could find it.  Question is, beside
> one is a CIV port and the other port is RS232, what if any advantage is
> there to using CIV rather than RS232?  Does rig control only work with the
> CIV port?  Or will it work with either port?
>
> Thanks
>
>
> 73
>
> Stan
> KM4HQE
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>