According to the circuit d3 is a synergy microwave cmp-a12 which seems is
not a valid part number.
Synergy microwave has no listing for it.
73's Lee
-----Original Message-----
From: TenTec <tentec-bounces@contesting.com> On Behalf Of L D Ritta
Sent: Friday, 14 September 2018 3:40 PM
To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
Subject: Re: [TenTec] omni 6 front end board
Hello Again
Anyone know what d3 is I guessing an mini circuits mixer.
One other thing any idea why they put 4 jfets in parallel both before and
after the mixer that is Q2 - Q5 and Q6 - Q9 comments please.
73's Lee.
-----Original Message-----
From: TenTec <tentec-bounces@contesting.com> On Behalf Of L D Ritta
Sent: Thursday, 13 September 2018 2:08 AM
To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
Subject: [TenTec] omni 6 front end board
Hello All
Anyone know what u1 ic is on the omni 6 front end board 81593 as I could not
find a listing, help.
Did ten tec ever release a parts list for the 563 omni 6
I have done a complete reset, but the receiver is pretty deaf
73's Lee
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|