| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Paragon585 |
| From: | ROLAND HOWELL via TenTec <tentec@contesting.com> |
| Reply-to: | ROLAND HOWELL <snowy.howell@btinternet.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 22 Sep 2018 12:35:51 +0000 (UTC) |
| List-post: | <mailto:tentec@contesting.com> |
Oh dear, I seem to have entered the wrong info on my last letter, so hopefully I can correct it.my comments ref the minor loop pcb should have read PLL/Oscillator pcb.On the minor loop pcb no output 2.1mHz on connector 85, no output on connectors 86-87 or are they inputs from pll oscillator/reference board.sorry for the mis-informationcheersSnowy _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Paragon 585, ROLAND HOWELL via TenTec |
|---|---|
| Next by Date: | [TenTec] Paragon 585, ROLAND HOWELL via TenTec |
| Previous by Thread: | [TenTec] Discussion of Ten-Tec Equipment, mark kenward via TenTec |
| Next by Thread: | [TenTec] OMNI Vl Model 563 - Carrier balance procedure & Tx in -Tx out jumper, Gregory Smith |
| Indexes: | [Date] [Thread] [Top] [All Lists] |