TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI
From: MadScientist <dukeshifi@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 30 Sep 2018 22:01:50 -0500
List-post: <mailto:tentec@contesting.com>
Pull cable marked “17” from the RF front end board and do the same test.

Gary

> On Sep 30, 2018, at 7:33 PM, Byron Cordes via TenTec <tentec@contesting.com> 
> wrote:
> 
> Ok I pulled 9mhz filter and no more noise when vfo turned. Put 9mhz back in 
> and pulled 6.3 and noise stopped. So noise coming out of mixer? 
> 
> Sent from my iPad
> 
>> On Sep 29, 2018, at 3:48 PM, Byron Cordes via TenTec <tentec@contesting.com> 
>> wrote:
>> 
>> Yes rx is ok and tx is ok . You can’t hear anyone from the clicking noise 
>> till you stop turning the vfo and when you stop it rx fine. 
>> 
>> Sent from my iPad
>> 
>>> On Sep 29, 2018, at 3:45 PM, MadScientist <dukeshifi@comcast.net> wrote:
>>> 
>>> OK, but, when this is happening, the radio still works fine (good TX and 
>>> RX), right?
>>> 
>>> Gary
>>> 
>>>> On Sep 29, 2018, at 3:44 PM, Byron Cordes via TenTec 
>>>> <tentec@contesting.com> wrote:
>>>> 
>>>> Radio has a click sound with each number on frequency readout when vfo 
>>>> knob turned. This is on 20meters and higher. 40 -160 works normally. 
>>>> Will look at radio again tomorrow night. 
>>>> 
>>>> Sent from my iPad
>>>> 
>>>>> On Sep 29, 2018, at 2:04 PM, MadScientist <dukeshifi@comcast.net> wrote:
>>>>> 
>>>>> Please explain this issue a bit more.
>>>>> 
>>>>> I am not clear of the meaning of the description "clicks for each number 
>>>>> “.
>>>>> 
>>>>> Do you mean you hear a click in the speaker or what?
>>>>> 
>>>>> Dose the radio otherwise work on the higher bands?
>>>>> 
>>>>> Gary
>>>>> 
>>>>>> On Sep 25, 2018, at 8:51 PM, Byron Cordes via TenTec 
>>>>>> <tentec@contesting.com> wrote:
>>>>>> 
>>>>>> Hi everyone 
>>>>>> I have a Omni VI that I’m down to one last problem.
>>>>>> On 20 meters or higher  when you turn the VFO the radio clicks for each 
>>>>>> number . Anyone have any idea? 
>>>>>> Thanks Byron AC9PA 
>>>>>> 
>>>>>> Sent from my iPad
>>>>>> _______________________________________________
>>>>>> TenTec mailing list
>>>>>> TenTec@contesting.com
>>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>> 
>>>>> _______________________________________________
>>>>> TenTec mailing list
>>>>> TenTec@contesting.com
>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>