TenTec
[Top] [All Lists]

[TenTec] Delta II alignment

To: Discussion of Ten-Tec Equipment <TenTec@contesting.com>
Subject: [TenTec] Delta II alignment
From: Greg Breeden <al0apsk31@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 8 Nov 2018 09:15:18 -0500
List-post: <mailto:tentec@contesting.com>
Folks,

Wondering if any of you have aligned their Delta II?? I am having a couple
of issues...let me outline below.

1) The rig displays a freq inaccuracy between tx and rx  in both CW and
Phone. On 160 meters
it is about 20 hz or so. The discrepancy widens by steps as you go up
the ham bands and eventually amounts to 200 hz or so on 10 meters and
quite noticeable on SSB.  I confirmed this by comparing it to my SDR
receiver.

2) There is some reduced output as you go up the ham bands. 100 watts
on 160, and about 80+ watts on 10 meters. This latter issue seemed to
coincide with the freq discrepancy and is new for this radio

Any thoughts? Can I fix this with an accurate Freq counter?

Greg, AL0A
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Delta II alignment, Greg Breeden <=